Member News > Architectural Standards


Controlled Burns Scheduled for Fall

Forestry Crew to Burn Slash Piles

During the fall season, the Tahoe Donner Association forestry department will once again be burning piles of vegetative debris throughout the property. The department has obtained two separate permits that allow us to burn material. A project burn permit has been obtained from Truckee Fire Protection District (TFPD), which gives us permission to burn numerous, larger piles than allowed under the residential burn permit. An additional air pollution permit has been obtained from the Northern Sierra Air Quality Management District. This permit provides guidelines on which days to burn large piles with proper air dispersion to avoid affecting the local population.

burn_map_2014
Download PDF map.

Before TDA forestry crews burn piles on any given day, we notify TFPD, CAL FIRE, US Forest Service and any agency that may see or be affected by the burning operation. Locally, TDA’s Member Services Office will have a list of the daily burning locations. At the burn site, signs will be posted notifying passersby of the operation.

The concentrated areas of burning to be completed include: Bennett Flat Road, Tundra Drive/KT Court, Falcon Point Place/Muhlebach Way, Northwoods Boulevard/Chamonix Road, Skislope Way, Cristallina Way and Euer Valley.

September 16, 2014


Are You Burning Debris Legally?



Burn permits are required for members of the association for debris burning. Burning season usually starts around the end of October. Once we receive several inches of measurable precipitation and it is deemed safe to burn piles, CAL FIRE will lift the burn ban in the Truckee area. Tahoe Donner does not regulate the burning of debris; however, burning in the association is only permitted once the burn ban has been lifted through Dec. 31 of a given year.

To burn dead limbs, pine needles and other vegetative debris collected from your improved property, you must obtain a residential burn permit from either the Truckee Fire Protection District (TFPD) located at 11473 Donner Pass Road or CAL FIRE located at 10277 Truckee Tahoe Airport Road. Undeveloped properties must obtain a project burn permit from TFPD as well as an air pollution permit. Once you obtain your burning permit and intend to burn on a given day, you must call 530-582-1027 to confirm it is a permissible burn day. Northern Sierra Air Quality Management District manages the burn day status with the predicted weather conditions. If it is a burn day, you must then call TFPD to report you are burning at your given location.

The following are burning permit terms for vegetative material:

• Maximum pile size is four feet in diameter.
• The area within ten feet of the outer edge of the pile must be maintained free and clear of all flammable material and vegetation.
• An adult must be in attendance with a shovel until the fire is out.
• A water supply must be located at the burn site.
• It is a good idea to cover your piles before fall rain to keep the material dry for efficient burning with little pollution.

If you have any questions about burning on your property, please call TFPD at 530-582-7850 or the forestry department of Tahoe Donner at 530-587-9432.

September 12, 2014


Tahoe Donner Residential Building Envelopes



Members often ask how and where they can develop their lot at Tahoe Donner. There are various zoning rules from the Town of Truckee combined with Tahoe Donner Association governing documents that regulate where you can build on your lot, often called the “building setback” or “building envelope.”

Building setbacks exist for many reasons. They enhance street aesthetics, create privacy by preventing buildings being constructed too close to one another, and also prevent encroachments and snow from possibly shedding across property lines. Another reason for the setbacks is to provide easements for access, recreation, erosion control, and utilities so local power and water companies may gain access to infrastructure.

Tahoe_Donner_Residential_Building_Envelopes_large
Download as PDF

Setback Lines:

  • Front Setback: Each lot includes an easement of snow storage by the Town of Truckee. These easements consist of a strip of land 20 feet wide at the front of each parcel and parallel to all roads (corner lots).
  • Side Setbacks: A minimum 10 foot side setback running parallel from the side property lot lines.
  • Rear Setback: Running parallel to the rear property lot line, a minimum rear setback is equal to 20 percent of the gross area of the lot or a minimum of 25 feet. The rear setback is intended to be preserved as a greenbelt area.
  • Building Height: The maximum height for any structure or improvement shall be 35 feet measured from the building’s midpoint on the downslope.
  • Maximum Lot Coverage: The maximum area to be surfaced including all buildings and paved areas is 35 percent of the total lot area.

Easements:

  • Utility Easements: Easements for installation and maintenance of utilities and drainage facilities are shown on the subdivision maps. These easements generally consist of 10 feet at the front of the Lot parallel to the road lines and five feet along and parallel to the rear and side lot lines if present. Within these easements, no structure, plantings or other material shall be placed or permitted to remain which may change or interfere with the installation and maintenance of utilities or which may damage, interfere or change the direction of flow of drainage facilities in the easements.
  • Recreational Easements: Recreational easements are shown on the subdivision maps. These easements typically consist of a 10 foot strip of land along the property line. In some cases, this strip of land could be much larger if running adjacent to the rear lot line. Within these easements, no structure of any kind shall be placed, erected, constructed or maintained, and no tree or vegetation shall be felled, cut, trimmed, pruned or removed, except as may reasonably be required by the association to construct and maintain trails and park sites therein and/or for the construction and maintenance of public and private utility easements shown on the subdivision maps.
  • Access Easements: These easements are created so an owner can gain access to a relatively steep lot. An access easement gives someone the right to travel across a designated strip of land owned by another person for ingress and egress purposes. Maps showing all access easements are maintained in the Architectural Standards Office.
  • Slope Easements: These easements were created to protect steep areas from erosion and sliding. No structure, plantings or other materials shall be placed or permitted to remain which may damage or interfere with established slope ratios, create erosion or sliding problems, or may change the direction of drainage channels.

More information can be found on easements and setbacks in Article VI and IX of the TDA governing documents, and pages 10 and 11 of the Architectural Standards Rules, Procedures and Restrictions for Land Use. If you have any questions regarding your building envelope or setback lines in relation a proposed structure or landscaping project on your lot please stop by the Architectural Standards Office for further assistance.

Sheryl Walker
Architectural Standards Manager

September 9, 2014


2014 Defensible Space Program

Get an early start on work that needs to be completed. Properties in Unit 2 (Lots 1-287) and Unit 8 (Lots 98-608) were inspected in the fall of 2013 for the 2014 defensible space work. Property owners who passed the initial inspection will be notified that their properties are in compliance.

For those properties that need to perform work, correspondence with inspection reports will be mailed out starting in mid-May with re-inspections beginning on July 7, 2014. Forty notices will be mailed per day; each property will have 45 days to complete the work.

Property owners may wish to start work earlier than usual this year due to the lack of snow. Paperwork can be emailed at owner’s request by contacting Dean Litchfield at dlitchfield@tahoedonner.com or by calling 530-587-9465.

April 21, 2014


Solar Panel Information

We would like to remind all Tahoe Donner homeowners who are looking into adding solar panels about the rules.  The solar panels we are seeing come in two forms, laying flat against the roof or siding and solar panels placed on high mounted steel racking systems and metal pans. If the solar panels you are looking to purchase have the high mounted racking system, please remember that the racking steel/metal system must be painted to match the adjacent material (roof or siding) along with any conduit added. No shiny metal is allowed.

A Neighbor Notification conducted by our office is required prior to review & approval. Also, you must have a permit through our office to add solar panels, which can be done over the counter Monday through Friday. The applications will be reviewed by one member of the Architectural Standards Committee every Wednesday. This type of permit is only good for 6 months. You can view the Solar Panels Change to Existing Structure Application for more information.

May 16, 2012


Tahoe Donner Homeowner Property Inspection Program

Get all the details on the Homeowner Property Inspection Program here.

Read More

Be Bear Aware

Be Bear Aware! Homeowner tips to avoid bear intrusions.

Read More